Twin Air filters are known in the motorcycle and ATV industry for their unmatched performance, and the Twin Air Dust Cover adds an additional layer for protection especially for extreme conditions. Twin Air designed the dust cover as a coarse pre-filter to withstand the extreme conditions of heavy dust and sand with amazing durability. Designed to extend the service time between filter cleaning, the Twin Air dust cover is a great investment into your motorcycle, even if you are not riding in extreme conditions. Twin Air designed the dust cover to fit over your Twin Air filter to achieve the best fitment.
"The trails I ride are very dusty(old coal mining place). I had to clean the twin air filter every time I went riding to keep good air flow. The dust cover still needs to be cleaned every ride but, it is so much easier to clean and oil then the filter. I can get about 3-5 (usually 5) rides without having to clean the air filter, sometimes more. Use twin air air filter and dust cover with no toil oil and cleaner."
The Pro Seal Air Filter Gasket is an added benefit to keep your intake clean and clear of those sneaky dirt particles. The typical air filter requires the use of filter rim grease to provide a seal, the Pro Seal Air Filter Gasket emilinates the need to use that messy grease. The Pro Seal Air Filter Gasket is constructed out of a durable neoprene material that is air tight. The neoprene material is resistant to gas and oils.
"No mess cleaning the grease off the rim and greasing when putting on air filter. just make sure you put it on right the first time. try fitting a couple times without taking off the back. Equivalent protection, if not better in my opinion."
As an industry leader, JD Jet Kits are a sure way to fine tune the performance of your motorcycle or ATV carburetor. Being field tested from sea level to 12,000 feet and put through stringent dyno testing, the JD jet kit provides an accurate way to tune your carburetor. This kit uses multi-tapered needles designed for Keihin and Mikuni carburetors that are more highly developed and fine tuned than stock parts. It is JD's prescription for the head pipe blues.
"I tried several different jetting setups and thought i finally found one. I was riding and kinda noticed it bogged and the throttle acted weird when going into the power band but once revved nice and high it seemed okay. So i didn't take too much notice until a fouled a plug. I used the recommended jetting setup from the JD kit and the yz125 has so much more power down low but especially more going into and in the power band. I can't believe how much crisper and responsive the throttle is.."
Competition Two Stroke Oil Developed to meet the requirements of competition Motocross and Snowcross. Used exclusively by the two stroke Yamaha Factory Race Team riders. Class-Leading Lubrication A special base stock protects from wear and breakdown, reduces friction and allows for maximum horsepower. Low Deposits Special, synthetic additives reduce carbon and deposit build-up on pistons, rings and exhaust ports, for maximum horsepower and minimum wear. Greatly reduced visible smoke. Competition grade. Semi-synthetic formula.
The IMS Pro Series 4 motorcycle foot pegs are designed to provide maximum comfort, control, and feel. IMS Pro Series 4 foot pegs are constructed of 17-4 cast stainless steel with a powder coated interior and polished exterior for the ultimate in aesthetics and durability. IMS Pro Series 4 foot pegs are larger than stock and measure in at approximately 2 x 3 inches. This larger platform provides better control and comfort. Patented tooth design with taller teeth on the outside edge of the pegs offer better feel and riding performance. Note: IMS Pro Series 4 foot pegs are sold in pairs.