Sure to be a hit with the tech set, these futuristic, flush-mount LED front marker lights have their circuit boards beneath the lenses. They mount in and/or cover up the stock signal holes. Available in Clear or Amber lens. Dimensions: 4.25" x 2.125" Sold in pairs.
"These signals look nice, though it took some work to mount them on my triumph speed triple. They don't fit exactly to the contours of the stock signal, but the rubber ring does a pretty good job of helping them blend in."
Upgrade the turn signals on your street bike to trick LED turn signals, but get rid of the rapid flash with the Lockhart Phillips LED Flasher Relay. The universal LED Flasher Relay installs in seconds with the quick connector to easily convert the flash rate back to stock. Note: the Lockhart Phillips LED Flash relay will adjust the flash on two turn signals.
"These are racing sliders. It might not spell it out on the site, but they are made for hitting the ground at speed. They may shatter in a low speed drop, so this might not be what you're looking for. Install is quick and easy, depending on how accessible/stuck your engine mounting bolts are (one of mine was a real bear!)"
Ballistic Performance Component Batteries use the latest, state of the art lithium ferrous energy storage technology available to provide you with a smaller, lighter, higher energy battery. Each Ballistic Performance Component Battery is assembled by hand in the USA using computer designed custom cells, cases, and hardware. As a result, Ballistic Performance Component Batteries will provide more energy out of a smaller package while requiring almost no regular maintenance and under most conditions a longer service life than existing lead acid batteries. The 16 Cell EVO2 is the biggest powersports battery Ballistic makes with burst amp capacity of 500 CCA at only 3.5 pounds of weight. The 16 Cell is meant for the most severe duty applications where maximum starting capacity is needed. This is the solution that modified Harley and drag racing riders have been searching for. The 16 Cell is a direct replacement of the Yuasa YTX30L-BS, GYZ-20HL, and YTX24HL-BS. Typical applications are large touring bikes, ATVs, watercraft, built sport bikes, and heavily modified Harleys. There is no special charger required, but periodic balance charging the 16 Cell EVO2 with the Ballistic Performance Components BMS charger will greatly extend the life of the battery. Dimensions: 114 mm (L) x 114 mm (W) x 112 mm (H). Dimensions (standard): 4.5" (L) x 4.5" (W) x 4.25" (H). Negative terminal location: Left. Cells: 16. Weight: 1633 grams (3.6 pounds). Voltage (charged): 13.6 V. Amperage: 28 Pb-eq A/H. Pulse cranking amps: 500 CCA. Operating environment: -18C (0F) to 60C (140F). Typical applications: Touring bikes, large modified Harleys, 1500cc and up multi cylinder motorcycles, jet skis, large side by sides and ATVs. Up to 80% smaller than the stock battery. Up to 10 pounds lighter than the stock battery. Service life of over twice a lead acid in similar conditions. Industry leading 3 year warranty. Designed, developed, and assembled in the USA. Completely "dry" technology so batteries can be mounted in any direction. Non-toxic, recyclable, and can be air shipped. Tested extensively by professional race teams. Impact and water resistant. Works with the original equipment charging system. No trickle charger required, loses only 10% of charge over a year of static use.
"I got tired of my battery needing constant tending if I didn't drive it everyday. Here in Austin, the driving season is all year, but in the winter we'll get some cold overnight lows. If you aren't really disciplined, your lead acid battery just isn't going to last more than 3 years.
I did a lot of forum searching between the Ballistic EVO2 and the Shorai and they seemed compatible products. The Ballistic folks had a much better customer service rep so I went with them. It's smaller and lighter and comes with some foam for you to pack it into your bike's battery compartment so it won't jostle. I've had it in for two weeks and my 1050cc speed triple has started like a champ, no complaints."
Used in many Targa Tail Kits for its qualities of durability, LED life and ease of application. Measures 2-3/8"L x 1/2"W x 3/16"H. Four (4) LEDs with flexible molded base and lens. Waterproof; totally sealed housing and lens. Fits flat and curved surfaces. No drilling; mounts easily with self-adhesive tape. 12 volts; 23" lead wire with 0.157 male bullet connector.
"It is exactly what is advertised. The strip is flexible and it comes with a two sided adhesive strip that is strong enough for me to have it mounted on a slightly curved surface. Keep in mind the lights shine straight from the strip so to illuminate a license plate the mounting surface will have to face slightly toward the plate. Nice and bright, though!"